Wifite has been around for some time and was one of the first Wi-Fi hacking tools I was introduced to. Along with Besside-ng, automated Wi-Fi hacking scripts enabled even script kiddies to have a significant effect without knowing much about the way the script worked. Compared to Besside-ng, the original Wifite was very thorough in using all available tools to attack a network, but it could also be very slow.
One of the best features of the original Wifite was the fact that it performed a Wi-Fi site survey before attacking nearby networks, allowing a hacker to easily designate one, some, or all nearby networks as targets. By laying out available targets in an easy to understand format, even a beginner could understand what attacks might work best against nearby networks.
The original Wifite would automatically attack WPA networks by attempting to capture a handshake or by using the Reaver tool to brute-force the WPS setup PIN of nearby networks. While this method was effective, it could prove to take 8 hours or more to complete.
The updated WiFite2 is much faster, churning through attacks in less time and relying on more refined tactics than the previous version. Because of this, Wifite2 is a more serious and powerful Wi-Fi hacking tool than the original Wifite.Attack Flow for Wi-Fi Hacking
Wifite2 follows a simple but effective workflow for hacking nearby networks as rapidly as possible. To do so, it pushes each tactic it tries to the practical limit, even going to far as to try to crack any handshakes it retrieves.
In the first step, Wifite2 scans across all channels looking for any network in range. It ranks these networks it discovers by signal strength, as a network being detected does not ensure you can reliably communicate with it.
Organized from strongest to weakest signal strength, the reconnaissance phase involves gathering information about what networks are around and which hacking techniques they might be vulnerable to. Because of the way Wifite2 is organized, it's easy to add a directional Wi-Fi antenna to use Wifite2 to locate the source of any nearby Wi-Fi network while performing a site survey.
After the site survey is complete, any targets displayed will show whether there are clients connected, whether the network advertises WPS, and what kind of encryption the network is using. Based on this, an attacker can select any target, a group of targets or all targets to begin an attack based on the information gathered.
Wifite2 will progress through the target list starting with the fastest and easiest attacks, like WPS-Pixie, which can result in a password being breached in seconds, on to less sure tactics like checking for weak passwords with a dictionary attack. If an attack fails or takes too long, Wifite2 will move on to the next applicable attack without wasting hours like its predecessor was prone to doing.
What You'll Need
To get started, you'll need a Wi-Fi network adapter you can put into wireless monitor mode. This means selecting one that is compatible with Kali Linux, which we have several excellent guides on doing.
Wifite2 is installed by default on Kali Linux, so I recommend you either use Kali in a virtual machine or dual-booted on a laptop. You can use Wifite2 on other Linux systems, but I won't go through the installation as this guide assumes you're using Kali Linux.
Step 1Install Wifite2
If you don't have Wifite2 installed on your system already, you can do so from the GitHub repository. First, you can clone the repository by opening a terminal window and typing the following commands.
This should download and install Wifite2 on your system. To test if it worked, you can type wifite -h to see information about the version installed.